List of processes¶
Please refer to the PDF manual in Doc/manual.pdf in the MCFM distribution for a full list of processes. This page is slowly being extended.
The processes described in the file process.DAT include appropriate
boson decays when the parameter removebr
is set to .false.
. In many
cases a more simple calculation can be performed by setting this
parameter to .true.
, in which case these decays are not performed.
Technically the full calculation including the decays is still performed
but cuts are not performed on the decay products and the branching ratio
is divided out, thus yielding the cross section before decay. In the
notes below we indicate the simpler processes thus obtained. When
running in this mode, the parameter zerowidth
should be set to
.true.
for consistency. However in certain circumstances, for the sake
of comparison, it may be useful to run with it set to .false.
.